Din 50961 Fe Zn 8b

High-current density areas (outer edges, threads, sharp corners) typically receive thicker layers.

The designation DIN 50961 Fe/Zn 8/B a technical specification used in engineering and manufacturing to describe a specific type of protective coating: electrodeposited zinc on iron or steel

The designation refers to a specific standard for electroplated zinc coatings on iron or steel. While this standard was technically replaced by DIN EN ISO 2081 , it is still widely referenced in engineering specifications to define coating thickness and finish. Designation Breakdown

the above mentioned directives. See figure 1 for an overview of our alternatives. Application data on zinc (Zn) and zinc coatings. www.mff.dk DIN 50961 Electroplated ZN Coating | PDF - Scribd www.scribd.com Electroplated coatings of zinc / zinc-alloy din 50961 fe zn 8b

Depending on your application environment, you may consider these alternatives:

: The German standard for electroplated zinc coatings. Fe : The base material (Iron or Steel). Zn : The coating material (Zinc). 8 : The minimum local thickness of the zinc layer (typically

DIN 50961 is a German standard that specifies the requirements for electroplated coatings of zinc on iron and steel. The standard is part of the Deutsche Normen (DIN) series, which is a set of technical standards developed by the German Institute for Standardization (DIN). The "FE" in the designation refers to iron and steel, while "ZN" represents zinc, and "8B" represents the thickness of the coating. Designation Breakdown the above mentioned directives

). The plated zinc layer must be at least 8 microns thick at any given reference point on the significant surfaces of the component. 5. B (The Chromate Conversion Coating / Finish)

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

The DIN 50961 standard was officially withdrawn and replaced by international standards to harmonize global manufacturing practices. If you are updating legacy drawings or sourcing parts internationally, the closest modern equivalents are found under . Cr(III) blue passivates are:

The designation DIN 50961 Fe/Zn 8b specifies a technical surface treatment for iron or steel parts involving electroplated zinc. Trojan Special Fasteners Ltd Breakdown of the Code:

The direct modern cross-reference for is: ISO 2081 Fe/Zn8/A (Trivalent clear/blue passivation)

Because a thickness of 8 microns offers light-to-moderate corrosion protection without altering thread tolerances heavily, DIN 50961 Fe/Zn 8/B is widely utilized for:

The letter defines the post-plating passivation or chromate treatment. Under the DIN 50961 framework, Group B refers to a Bleached to Clear/Blue finish. This treatment enhances corrosion resistance and gives the part a bright, slightly iridescent blue or clear silver appearance. Technical Specifications and Performance Specification Substrate Compatibility Iron, Low-alloy steel, Carbon steel Minimum Zinc Thickness Passivation Type Group B (Clear / Blue / Bright) Appearance Bright metallic silver with a subtle blue hue Hexavalent Chromium Status

Today, compliant coatings must use trivalent chromium (Cr(III)) passivation. However, Cr(III) blue passivates are: