If the output percentage is consistently at 100%, your brake or clutch may be undersized for the application.
: Receives signals from LX-TD tension detectors and controls 0-24V for powder clutches/brakes or 0-5V for servo amplifiers. mitsubishi tension controller le 30 cta Manual
A frequent error in the is the recommendation to short the unused sensor wires if only one tension detector is connected. Specifically, if only one side is used, the Green and White wires of the unused side must be shorted together. If the output percentage is consistently at 100%,
The LE-30CTA is an automatic tension controller designed primarily for use with powder clutches, brakes, or AC servos. Specifically, if only one side is used, the
Press and hold the MODE key for approximately 2 seconds to enter the programming menu. Select Parameter: Use the arrow keys ( ) to cycle through parameter codes (e.g., Pr.01 , Pr.02 ).
(100Ω or less) using at least 2mm² wire. Never share grounding with strong electric systems to avoid noise interference. Wiring Separation: Keep control lines at least 100mm (3.94")
This section provides diagnostic guidance for common issues: