!!hot!! — Lenel Lnl3300m5 Installation Manual Upd Top

!!hot!! — Lenel Lnl3300m5 Installation Manual Upd Top

is a highly capable intelligent controller designed specifically to modernize legacy security systems. It serves as the cornerstone of the migration strategy, allowing for a straightforward upgrade from older CASI M5, M3000, and similar systems to the advanced Lenel OnGuard platform. This article provides a comprehensive overview based on the LNL-3300-M5

15 MB onboard flash memory for database and event storage. Panel Layout and Components

Power down the legacy CASI controller and unplug all field wiring from the existing legacy boards.

Supports up to 240,000 local badge holders and 50,000 offline events. Compatibility:

Reserved for specific system operational parameters. Switch 8 (Cold Start): Used to clear the database memory. lenel lnl3300m5 installation manual upd top

Dedicated serial port for diagnostics or configuration.

| Device Address | Switch 1 | Switch 2 | Switch 3 | Switch 4 | Switch 5 | | :--- | :--- | :--- | :--- | :--- | :--- | | | OFF | OFF | OFF | OFF | OFF | | 1 | ON | OFF | OFF | OFF | OFF | | 2 | OFF | ON | OFF | OFF | OFF | | 3 | ON | ON | OFF | OFF | OFF | | 4 | OFF | OFF | ON | OFF | OFF | | ... | ... | ... | ... | ... | ... | | 31 | ON | ON | ON | ON | ON |

Always check for the latest firmware to ensure security patches are applied. Conclusion Lenel LNL-3300-M5

DIP switch S1 configures the communication settings for the downstream channel. Panel Layout and Components Power down the legacy

If a reader fails to power up on the LNL-1320-2RP:

The LNL-3300-M5 acts as a direct replacement for legacy central processing units. It communicates downstream with legacy interface boards and upstream with the OnGuard server over an Ethernet connection. Key Specifications 12 VDC ± 10%, 300 mA maximum.

Shut off the 12V DC power source feeding the enclosure. Disconnect the backup battery.

The device address is assigned using binary weighting. Switch 1 represents the lowest value (1), and Switch 5 represents the highest (16). Turn on the combination of switches that equals the desired address (1 to 31). 02 03 04 Baud Rate Selection (Switches 6 and 7) Switch 8 (Cold Start): Used to clear the database memory

Always wear a grounded ESD wrist strap when handling the controller board to prevent permanent damage to the circuitry. 3. Physical Installation Steps Step A: Mounting the Board

Because the board installs inside legacy enclosures, handling rules are stringent. Electrostatic discharge (ESD) can easily disrupt modern microprocessors.

The reader port supports Wiegand or Clock-and-Data signalling structures. Reader Power Out (+5 VDC or +12 VDC pass-through) TB4-2: Data 0 / Data TB4-3: Data 1 / Clock TB4-4: Green LED Output TB4-5: Red LED Output TB4-6: Buzzer/Beeper Output TB4-7: Ground 4. Alarm Inputs (TB2)

platform. It serves as a direct, plug-compatible replacement for legacy CPUs (such as E, P, PX, or PXNplus) and power/comm boards, allowing for a "one-for-one" hardware swap without requiring new field wiring. Hitron Bina Teknolojileri Core Installation & Setup Installation of the LNL-3300-M5 is designed for high speed and minimal disruption: Hardware Migration

Connect the Ethernet cable to the onboard 10/100 MB port for host communication.

Connect the 12–24 VDC power source to the dedicated power input terminal block (typically labeled VIN+ and VIN-).