Activate the corresponding button to control a fixture set to these standard starting addresses: Scanner 1 : Address 1 Scanner 2 : Address 17 Scanner 3 : Address 33 Scanner 4 : Address 49 Scanner 5 : Address 65 Scanner 6 : Address 81 Scanner 7 : Address 97 Scanner 8 : Address 113 Scanner 9 : Address 129 Scanner 10 : Address 145 Scanner 11 : Address 161 Scanner 12 : Address 177 Physical Connection Steps
Now that the hardware is set up, let us program a simple chase.
To ensure your controller lasts, the manual lists several crucial rules: disco 240 dmx controller manual
A scene is a static snapshot of your lighting look. Programming involves setting fader positions and saving them to a specific Bank and Scene button. Step-by-Step Scene Recording
DMX-512 is a digital communication protocol used to control lighting equipment. The DMX Operator 240 transmits 512 channels of data (0-255 values) via RS-485. Always use shielded twisted pair cable (not standard microphone cable). Maximum cable length: 300 meters. Maximum fixtures per line: 32 (use a splitter for more). Activate the corresponding button to control a fixture
Select the next scene for your sequence and press again. Repeat this process for up to 240 steps in a single chase.
If you have programmed your lights into a specific "look," you can recall it instantly. While in (EDIT/RUN LED off), press the RUN SCENE button followed by a P1 – P12 button. This recalls a pre-programmed snapshot. Maximum cable length: 300 meters
Hold down the button for roughly 2 seconds. The PROGRAM indicator on the display will flash. B. Creating Scenes Enter Program Mode . Select a Bank (01-30) using the Up/Down buttons.