The is the primary technical resource for maintaining, installing, and repairing the Standard 20 system. This system is known for its absolute digital position pick-off and microprocessor-controlled heading correction. Core System Components
Measure the resistance of the heating mat. Replace the sensor if the temperature readings do not change during startup. EL2: Follow-Up System Failure anschutz gyro compass standard 20 service manual
sec Lat. RMS) for marine navigation. The system components include: The is the primary technical resource for maintaining,
Use shielded, marine-approved cables for NMEA 0183/Step/Synchro outputs and separate them from high-voltage power lines. 3. Routine Maintenance Procedures Replace the sensor if the temperature readings do
Press to commit the offset to the non-volatile memory (EEPROM). Restart the master unit to verify the calibration holds. Spare Parts List and Ordering Guide
The Master Compass must be mounted parallel to the ship’s center line. Use the precision alignment marks machined on the base of the compass housing.
Servo motor failure, loose drive belt, or defective follow-up amplifier board.
Call Us