Hyt Tc-500 Programming Software «Plus | 2025»

, she firmly seated the 2-pin connector into the side port of the TC-500. The Driver

If your software only gives options for COM1 and COM2, but Windows assigned your USB cable to COM12, you must change it. Go to Windows Device Manager -> Port Properties -> Advanced, and manually reassign the cable to an open lower port number (like COM2 or COM3).

Windows XP, 7, 8, 10, or 11 (Legacy software may require running in "Compatibility Mode" on newer Windows versions).

Digital codes (e.g., D023N).Both the transmitting and receiving radios must have matching codes entered in the Rx Analog/Digital Sub-audio and Tx Analog/Digital Sub-audio columns to hear one another. Optional Features and Global Settings Hyt Tc-500 Programming Software

: Set the privacy tone your radio transmits to alert other radios or open a repeater.

Select Wide (25 kHz) or Narrow (12.5 kHz) based on local regulatory compliance standards. Adjusting Optional Features

Typically set between 3 and 5. Lower numbers make the radio more sensitive to weak signals but prone to static; higher numbers require a stronger signal to break through. Writing Settings to the Radio Once your channel grid is correctly filled out: , she firmly seated the 2-pin connector into

Locate the main channel information table. For each channel (1 through 16), you can configure:

If the software shows "Abnormal detection data," try restarting the radio or re-opening the application.

If the software can't see the cable at all, you likely need to update or roll back your USB-to-Serial drivers. Windows XP, 7, 8, 10, or 11 (Legacy

Set your COM port to 9600 baud, 8 data bits, no parity, 1 stop bit in Windows Device Manager.

: Set the privacy tone needed to open your radio's squelch.

: Enter the transmitting frequency. For simplex operations, this matches the RX frequency. For repeaters, input the repeater's input frequency.