Connect the Niton XLt 898 to your PC using the specialized serial or USB data cable.
Connect the instrument to a computer using the provided RS-232 data cable. Open the on your computer platform.
Press and hold the trigger or select on the touchscreen interface.
Clean the measurement window film and retest the 316 check coupon. Tube pre-heating sequence Niton Xlt 898 User Manual
Press and hold the power button for several seconds. The unit requires a brief boot-up period to initialize the system electronics and the high-resolution Si-PiN detector.
: RS-232 serial port and Bluetooth capabilities. 🚀 Step-by-Step Initial Setup
When operated strictly according to instructions with the primary shutter open, the maximum radiation dosage to which an operator is exposed is on the fingers holding the instrument handle. Mandatory Safety Features Connect the Niton XLt 898 to your PC
Slide a fully charged lithium-ion battery pack into the handle base until it clicks into place.
While this guide covers the essentials, the manufacturer's full remains the authoritative source for your Niton XLt 898. Thermo Fisher Scientific has transitioned to providing 100% digital documentation for all its instruments since 2017.
| Symptom | Likely Cause | Fix | |---------|--------------|-----| | No power | Dead battery | Recharge; check cradle contacts | | “Interlock error” | Window missing or safety shutter stuck | Replace window or contact service | | High counts / unstable | Cracked window | Replace Prolene film | | Low counts / long test time | Dirty window, thick paint, or wrong mode | Clean window; grind sample; switch to Alloy Plus | | Wrong alloy ID | Surface contamination or small sample | Clean sample; use workstand with masking | | Cannot connect to PC | Baud rate mismatch | Set 9600, N, 8, 1 on both XLt and PC | Press and hold the trigger or select on
The Niton XLT 898 User Manual provides comprehensive guidance on the proper use, operation, and maintenance of the instrument. The manual outlines key features and functions, operating procedures, measurement modes, and maintenance and troubleshooting tasks. It also provides important safety and regulatory information to ensure safe and compliant use of the instrument. By following the guidelines outlined in the manual, users can ensure optimal performance and accuracy of the Niton XLT 898.
). When conducting high-temperature PMI, operators must minimize direct contact intervals to short 5-to-10 second intervals to prevent heat transferring into the Si-PINSi-PIN
Inspect the thin Kapton window membrane daily for punctures. Replace torn window films immediately to keep dust out. Troubleshooting Codes Symptom / Error Probable Cause Corrective Action Contaminated window or sample Clean window; retry with fresh reference block. Yellow Warning Light Shutter failed to close fully Power down immediately; inspect for debris. No Power Depleted or unseated battery Re-seat the battery pack or swap for a charged pack. High Error Bars Insufficient testing duration Extend the analysis count time by 10–15 seconds. 💾 Data Transfer and Reporting