Mitutoyo Surftest Sv400 User Manual !full! Full Guide

Connect the drive unit interface cable to the rear of the control unit or PC interface card.

Typically 50mm or 100mm travel lengths.

The distance between the highest peak and the lowest valley within the evaluation length.

You can download the Surftest SJ-400 Series Manual directly from the Mitutoyo official website. mitutoyo surftest sv400 user manual full

The Surftest SV-400 is typically operated via a dedicated keyboard/display controller or through Mitutoyo’s proprietary software windows. Key Operator Keys / Software Commands

for maximum accuracy. Avoid direct sunlight and air conditioning drafts.

radius). The stylus tracks surface peaks and valleys, translating mechanical movement into electrical signals. Connect the drive unit interface cable to the

The manual highlights several "Best Practices" that users frequently overlook:

Raise the Z-axis instantly. Readjust the starting Z-height positions within the green graphic safety boundaries.

Interchangeable styli allow for measurements in hard-to-reach areas. You can download the Surftest SJ-400 Series Manual

Turn on the control unit/PC, followed by the SV-400 main power switch. Launch the measurement software (e.g., SURFPAK). Perform the system axis homing sequence ( axes) to establish the machine coordinate system. 4. Calibration Procedure (Step-by-Step)

: You can switch between skidded mode for tracking workpiece contours and skidless mode for accurately measuring waviness and fine steps. High Resolution

Equipped with an 800µm detector range and resolution as fine as 0.000125µm.

Check cable seating. Inspect the stylus tip under a microscope for chips. Mechanical obstruction blocking the drive unit path.