If you have followed the 95 lb-ft + 90° for mains and 75 lb-ft + 60° for rods, your rotating assembly is mechanically sound. Now prime the oil system before startup—but that is a topic for another article.
Ensure your torque wrench and torque-angle meter are calibrated. The ISX relies heavily on Torque-Plus-Angle sequencing. Cummins ISX Main Bearing Torque Specs
: Apply a u-shaped bead of Loctite™ 518 thread sealant to the mating surface of the main cap joint, ensuring it does not enter the bearing shell. Cummins ISX Connecting Rod Bearing Torque Specs (New Bolts)
If you are unsure which bolt you have, look at the head of the bolt and consult the parts book for your Engine Serial Number (ESN). Never reuse Torque-to-Yield bolts. If you remove them, they must be discarded and replaced. cummins isx main and rod bearings torque specs new
0.13 to 0.43 mm [0.005 to 0.017 in]. 3. Use an Angle Gauge
Modern Cummins ISX engines use a torque-plus-angle method for critical fasteners. Measuring final rotation in degrees ensures consistent bolt stretch and clamping force, which conventional torque wrenches cannot achieve due to friction variance.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. If you have followed the 95 lb-ft +
Do not tighten the bolts from one side of the engine to the other. You must start from the center main cap and work your way outward in a cross-pattern to prevent crankshaft binding. Start at Cap No. 4 (Center) Move to Cap No. 3, then Cap No. 5 Move to Cap No. 2, then Cap No. 6 Finish with Cap No. 1 (Front) and Cap No. 7 (Rear) Cummins ISX Connecting Rod Bearing Torque Specs
Retighten all main bearing capscrews to 70 N•m [52 ft-lb] .
This article details the specific torque procedures for new rod and main bearing caps for the Cummins ISX, along with best practices to ensure longevity, based on industry standards and official Cummins documentation . 1. Important Prerequisites: New vs. Used Fasteners The ISX relies heavily on Torque-Plus-Angle sequencing
Main capscrews should also be replaced during a full overhaul.
Are you using or aftermarket options like ARP bolts ?
Note: After the final 90-degree turn, verify that the crankshaft rotates freely by hand. If it binds, a bearing may be misaligned or a cap may be seated incorrectly. Cummins ISX Rod Bearings Torque Specs
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.