In Cisco Packet Tracer Link Free: Media Converter
The default model has:
[Switch A: Copper Port] <--- UTP Cable ---> [Media Converter 1] <=== Fiber Cable ===> [Media Converter 2] <--- UTP Cable ---> [Switch B: Copper Port] Follow this sequence to link your nodes together properly: 1. Connect Copper Side (LAN)
This article explores what a media converter is, how it functions in Packet Tracer, and how to create a working media converter link. What is a Media Converter?
The media converter is a humble but essential device in a network engineer's toolkit. In Cisco Packet Tracer, mastering the setup allows you to simulate realistic campus backbones, connect legacy equipment to modern fiber rings, and understand the critical difference between Layer 1 and Layer 2 devices. media converter in cisco packet tracer link
enable configure terminal interface fastEthernet 0/1 no shutdown switchport mode access switchport access vlan 10 exit interface fastEthernet 0/2 no shutdown switchport mode access switchport access vlan 10 exit vlan 10 name LINK_VLAN exit
Locate the virtual on the right side of the switch image. Click it to turn the device OFF . Look at the left menu for available modules.
Drag the module into an empty expansion slot on the back of the device, then flip the power switch back to ON . 🔍 Troubleshooting Link Status & Signal Loss The default model has: [Switch A: Copper Port]
A media converter is a networking device that connects two different types of media—most commonly copper (RJ45) and fiber optic—to work together within the same network.
Fiber modules often run at fixed speeds. If your copper side is Gigabit (1000 Mbps) and your fiber side is FastEthernet (100 Mbps), the link will fail. Ensure both sides match or configure manual speeds using the speed command in the CLI.
example to test this fiber-to-copper link in your simulation? The media converter is a humble but essential
From PC-A, ping PC-B:
:
This brings us to the central challenge. A common and often frustrating question for students and new users is: "Where is the media converter in Cisco Packet Tracer?"
Select the cable tool (represented by an orange solid line). Connect the Media-Converter switch (FastEthernet1/1 - your fiber slot) to Switch-B .
Note: Some devices are "Fixed Configuration," while others are "Modular." You need a device with an slot. 2. Add the Fiber Module (SFP) Click on the Switch to open its configuration window. Go to the Physical tab.