Phison Mpall V5.13.0c Jun 2026

Unscrew the USB casing (if possible) and look for a black rectangular chip with "Phison" and a model number starting with "PS".

Save the configuration, saving over or creating a new default MP.ini file in the main MPALL folder. 3. Execution via MPALL

However, its power comes with significant and often-overlooked risks. Because the software is not officially supported by Phison and must be downloaded from unofficial sources, there is a real danger of bricking your USB drive, causing system instability, or exposing your computer to malware.

: Allows for advanced partitioning, such as creating a fixed disk partition, a CD-ROM emulation partition, or encrypted areas. Write Protection Removal Phison Mpall V5.13.0c

Flashing microcontrollers can be notoriously finicky. If your flash fails, look closely at the error codes displayed in the MPALL user interface grid slot. 1. Error Code: 0x1042 (CT - Flash Read Error / ISP Fail)

Hard-codes an ISO file onto the controller chip so the USB drive registers in Windows as a physical CD-ROM/DVD-ROM drive (ideal for unbrickable bootable toolkits).

Unzip the MPALL distribution to a folder and ensure the firmware files (if needed) are in the same directory or a known path. 2. Hardware Detection Plug in your USB drive. MPParamEdit_F1.exe Unscrew the USB casing (if possible) and look

: It can overwrite corrupted firmware by matching specific "Burner" (.BN) and "Firmware" (.FW) binary files to the drive's unique Flash ID (FID) .

Click on the button. Choose "New Setting" and click OK.

Select your exact controller model (e.g., PS2251-07 ) from the dropdown menu. Execution via MPALL However, its power comes with

You must open the plastic casing of the USB drive and enter Hardware Test Mode . Use a needle or a small flathead screwdriver to carefully short the data pins (typically pins 29 and 30) on the NAND flash memory chip while plugging it into the computer. This forces the controller into a generic safe state, allowing MPALL v5.13.0C to see the device. Conclusion

Configure batch/auto mode

: Execute MPALL_F1_7F00_DL07_v513_0C.exe , load the configuration, and press "Start." If the drive is not detected, it may need to be put into Test Mode (physically shorting pins on the controller). Troubleshooting & Limitations